Hi,

I was experimenting with texteffector and tried turning on motion blur for some text that was animated using a position effector and it didn't do anything. But when I adjusted the actual value of the position effector, as I was changing the value the viewport showed motion blur, but when I actually hit play the motion blur wasn't there.

I then went back and looked at cloner and again no blur blur on play, but adjusting values of the position effector the blur is there, but not when...

Hi all,
where can I find my dongle serial number?
I know it's written on the box but I have 10 dongles and 10 boxes...
Cheers.

I have a 25 second moving shot where the camera pans as someone walks across a room and removes a curtain that is draped over a large framed picture to unveil a green screen picture where one can key out the green screen and add their own image. The workflow I have used so far in Resolve's Fusion is as follows:

1. It starts with the Media in node connected to the Media out node
2. I move the time line at the end of the shot to reveal the green screen picture frame.
3. I add a Delta Keyer node...

Hi everyone,

I'm working 99% with Arri Alexa LogC footage.
Gamut is AWG - Arri Wide Gamut aka Alexa Wide Gamut.
I'm getting 16Bit DPX Sequences from the editing room, pulled from ProRes 4444 (sometimes XQ) 12Bit .mov's. (3200x1800).

Last week I had to teach my colleague (After Effects User) how to work in Fusion :D
After explaining the linear workflow to him (CineonLog node: Log to Lin after the Loader - Lin to Log before the saver)
- he asked: and in which Gamut we are working now?
Yessss,...

Hi everyone, hope you are doing great.

Does anyone know how to calculate Color Temperature and Tint like the sliders that are in the White Balance Section in Lightroom?

Thanks in advance,
David

Hi all, I'm new in Fusion and that's my first post here. I've setup a comp which involves tracking, compositing gun smoke, some blood and thats it. The problem is that the director asked for 18 frames 'slip to the right' (Adobe Premiere term) which means +18 frames offset to the IN-OUT of the Loader>Trim. I cant figure out how to offset the rest of the nodes with a little or no effort. I tried grouping them and slip the group in the keyframe editor but it doesnt work, and honestly I dont know...

I have two GPU. When Auto is selected in preferences, Ram preview is less than 24fps(very rarely 24fps).
Probably all the resources are taken up by the GPU calculations. Fusion's view is OpenGL. For me, Select mode was the solution.

Preferences > GPU > Device > Select
GPU1(OpenGL) is OFF : This is connected to monitor
GPU2 is On

But in v17.1.1, when I use select , some node has GPU session error . In v17.1, Fusion will not start in Select mode.

How about you?

Thank you.

Hey guys,

I am not terribly technical but have had a year or so experience with Davinci Resolve and now with the Studio paid Version 17.1.1

A couple of days ago I downloaded and installed Reactor 3 and all seemed normal. I tried doing a comp but noticed that I had lost all ability to access any tabs in the Inspector and can't set key frames to anything. All other tabs in Resolve seem to work fine (Cut, Edit, Color and Fairlight) Fusion is now like a cat that got ran over by a car.

The only...