< Previous | Contents | Next >
The Settings tab in the Inspector is also duplicated in other Stereo nodes. These common controls are described in detail at the end of this chapter in “The Common Controls” section.
Splitter [Spl]
The Splitter node
NOTE: The Splitter node is available only in Fusion Studio and DaVinci Resolve Studio.
NOTE: The Splitter node is available only in Fusion Studio and DaVinci Resolve Studio.
NOTE: The Splitter node is available only in Fusion Studio and DaVinci Resolve Studio.
Splitter Node Introduction
The Splitter takes a stacked input image—for example, created with the Combiner—and provides two output images: a left eye and a right eye.
Inputs
The two inputs on the Splitter node are used to connect the left and right images.
— Left Input: The orange input is used to connect a stacked stereo image.
Outputs
Unlike most nodes in Fusion, the Splitter node has two outputs for the left and right eye.
— Left Output: This outputs the left eye image.
— Right Output: This outputs the right eye image.
Basic Node Setup
Below, a stacked stereo image is connected to the input on a Splitter where a left and right eye is output.
A Splitter node creates a left and right image from a stacked stereo image